Q & A
Home > Worldwide > Q & A
1. No display in the control panel?
2. Control panel display is normal but system will not operate?
Ensure that the sliding switch between the two-point set is open.
3. Pump runs continuously? (an no signs of leaking fluid)
4. Clamp does not hold die securely?
5. Clamp does not hold die securely?
Turn off die lifter so that lower die clamp can return to normal operation.
6. Die lifter dies not rise?
Turn off lower die clamp so die lifter will return to normal operation.
7. Air pressure is insufficient and hydraulic pressure too low?
Check to see that compressor is turned on and air lines are free and clear, if there are no problems with the air supply, inspect the air pressure regulator on top of the two-point set and adjust the pressure as needed. (Check first to see if PU hose is ruptured or damaged.)